Image Not Available
Services Available | |
---|---|
Repair | No |
Calibration | No |
Free Support | No |
The Raven II was configured for or AT&T digital cellular networks. It supported telecommunications between a data logger and a cellular digital packet data (CDPD) network. CDPD modems were IP based, which required the cellular provider to assign an IP address.
Transmit Power | 600 mW |
Transmit | 824 to 849 MHz |
Receive | 869 to 894 MHz |
Data Rates | 9.2 kbps via TCP/IP, 1,200 to 38,400 bps via serial interface |
Input Voltage | 9 to 30 Vdc |
Input Current | 30 to 450 mA |
Typical Current Drain @ 12 Vdc |
|
Operating Temperature Range | -30° to +70°C (with transmissions limited to a 10% duty cycle above 60°C) |
Humidity | 5% to 95% (non-condensing) |
RF Protocol | CDPD 1.1 |
Serial Interface | RS-232, DB-9F |
RF Antenna Connector | 50 ohm TNC female |
Serial Protocols | AT Commands, SLIP, PPP |
Status LEDs | Power, Channel Acquired, Link Status, Network Registration, RSSI, Transmit/Receive, Block Errors |
Note: The following shows notable compatibility information. It is not a comprehensive list of all compatible or incompatible products.
Product | Compatible | Note |
---|---|---|
21X (retired) | ||
CR10 (retired) | ||
CR1000 (retired) | ||
CR10X (retired) | ||
CR200X (retired) | ||
CR206X (retired) | ||
CR211X (retired) | ||
CR216X (retired) | ||
CR23X (retired) | ||
CR295X (retired) | ||
CR3000 (retired) | ||
CR500 (retired) | ||
CR5000 (retired) | ||
CR510 (retired) | ||
CR800 (retired) | ||
CR850 (retired) | ||
CR9000 (retired) | Although the CR9000X and CR9000 are compatible, the Raven II does not support their fastest communication rates and therefore is not practical for most of their applications. | |
CR9000X (retired) | Although the CR9000X and CR9000 are compatible, the Raven II does not support their fastest communication rates and therefore is not practical for most of their applications. |
We've updated our privacy policy. Learn More
Update your cookie preferences. Update Cookie Preferences