Services Available | |
---|---|
Repair | No |
Calibration | No |
Free Support | No |
The CS440 submersible pressure transducer output a 4-20 mA signal to indicate observed pressure level. The CURS100 was typically used to convert the 4-20 mA signal to a millivolt signal. The data logger then converted the millivolt signal to user-selected units (such as psi or feet). The static accuracy was ±0.1% over a 0° to 50°C temperature range.
Read MoreThe CS440 was removed from our pricing system on August 22, 2008.
Excitation | 8 to 24 Vdc |
Static Accuracy | 0.1% span BFSL |
Operating Temperature | 0° to 60°C (non-freezing) |
Diameter | 2.5 cm (1.0 in.) |
Cable Diameter | 0.74 cm (0.29 in.) |
Length | 33.0 cm (13 in.) |
Note: The following shows notable compatibility information. It is not a comprehensive list of all compatible or incompatible products.
Product | Compatible | Note |
---|---|---|
21X (retired) | ||
CR10 (retired) | ||
CR1000 (retired) | ||
CR10X (retired) | ||
CR200 (retired) | ||
CR205 (retired) | ||
CR206 (retired) | ||
CR210 (retired) | ||
CR211 (retired) | ||
CR215 (retired) | ||
CR216 (retired) | ||
CR23X (retired) | ||
CR295 (retired) | ||
CR3000 (retired) | ||
CR500 (retired) | ||
CR5000 (retired) | ||
CR510 (retired) | ||
CR800 (retired) | ||
CR850 (retired) | ||
CR9000 (retired) | ||
CR9000X (retired) |
The CS440 is measured with a single-ended data logger instruction after converting the sensor signal from milliamps to millivolts using a 100 Ohm resistor.
We've updated our privacy policy. Learn More
Update your cookie preferences. Update Cookie Preferences