I have a base and a remote station. At the remote station I am collecting pressure, temperature and relative humidity (PTU) data on a 5 minute average. My base station has a laptop with loggernet 4.0. I have an RTMC screen where I would like to display the PTU data from station 1 every 5 minutes without collecting station's 1 data table. I have two programs: 1) Base and 2) Remote Stn 1.
How can I add code to the base program to get the PTU data every 5 min so I can point my RTMC screen to display the PTU data?
I am using RF450 radios. I have seen the GET VARIABLES command used with SDI12 sensors but in this case we are just trying to retrieve the TPU data from a remote CR1000 datalogger.
Any advice would greatly be appreciated.
Thank You
Wx2day
If I understand what you want to do, then GetVariables should work fine.
Dana W.
I think you could use CR1000‘s COM1(C1 C2),the commond you could use the SendGetVariables SendVariables SendData,the different is the time,you could check the help,it could work.