Hi there !
I just started learning to use the CRBasic, and I've run into a problem. A customer wants to change the data storage system that already has a CR1000 from Campbell, and I'm working on the program so far have had no problems I have configured and tested all the sensors and everything was working correctly is measuring and . But I found the problem that the installation has a pressure sensor 61220 Young, older, I know. The problem is that I give more laps for more forums, manuals and websites I see in google I can not run the program. I bought a cable and using TELNET TTL I could check it out properly.
I hope someone can please help me
Thank you.
I believe that barometer has a voltage output, so you could resort to that if you do not get the serial communication worked out.
Without the sensor manual, I can't give much guidance.
Refer to the application note on serial sensors for some general direction.
https://s.campbellsci.com/documents/us/technical-papers/serial.pdf
Manual:
http://www.tera-db.es/Manuals/1.pdf
I have no idea how i will do it. I hope you can help me.
Thanks