Hi All,
I have an conductivity instrument (consort K912) that spits out data every 5 seconds in RS232 (1200 baud) and then saves it to a SM4M storage module.
I want to read this in with my CR10x using P15.
Can I connect the RS232 output from the instrument directly into the CS I/O port to read in the serial data? Or do I need to go to the RX and TX lines.
Here is my code:
};CR10X
MODE 1
SCAN RATE 10
1:P30
1:62
2:0
3:1
2:P30
1:63
2:0
3:2
3:P15
1:1
2:1
3:10
4:13
5:1
6:1
7:13
8:100
9:1000
10:3
11:1
12:0
4:P92
1:0
2:10
3:10
5:P80
1:1
2:201
6:P77
1:1220
7:P70
1:4
2:3
8:P96
1:71
9:P0
Thanks
You may not read in serial data on the CSI/O port of a CR10X. You will need to use the control ports.