FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1992 total: showing 1061-1080)

Can an ST-21 be used for both transmitting and receiving data?
How are data downloaded using satellite communication?
What type of field check can be done on a temperature sensor or a temperature and relative humidity sensor to determine if it is within the range of specified accuracy or if it requires calibration?
How are temperature sensors such as the 107, 108, 109, 110PV-L, and BLACKGLOBE-L calibrated?
Can the fan of the ASPTC-L be turned off when the temperature falls below -10°C?
Why does the ASPTC-L have a minimum operating temperature of only -10°C, when most of the Campbell Scientific products are rated down to -30°C or colder?
Can the ASPTC-L and a sonic anemometer be used to measure high-frequency temperature fluctuations needed to find sensible heat flux using the eddy-covariance technique?
Should the ASPTC-L fan(s) be turned off at night to save power?
If the thermocouple in the ASPTC-L breaks, can it be replaced in the field?
What might cause a connection issue between a data logger and an NL240 in LoggerNet?
How can two data loggers be connected to a single NL240 device?
Is the NL240 compatible with a WPA-Enterprise network?
Does the NL240 come with a whip antenna?
What are the powering options for the NL201 and NL240?
How many LWS sensors can be connected to an AM16/32B multiplexer?
What advantages does the LWS have as compared with the 237-L?
How can more storage be added to a CR1000 or CR3000?
What might cause the inability to transfer data from a data logger to a memory card?
What might cause a “CardStatus Unable to access Card. errno: 42” message? What does this message mean?
Can data be retrieved using a wireless connection while data is being stored to a memory card?

Previous Next